Instruction manual
9
Attach the iPad enclosure to a table or desk
You have the option to attach the SECTBLTPOS to a table or desk in a fixed position or
one that rotates.
1. Line up the holes on the mounting bracket (
1
) with the four holes on the back of the
rear plate (
3
).
2. Use the four M4x8 mm hex screws (
8
) and the 2.5 mm Allen key (
9
) to attach the
mounting bracket to the rear plate.
3. Do one of the following:
• If you want to be able to rotate the SECTBLTPOS, make one hole in the top of
the table or desk that you want to attach the SECTBLTPOS to.
• If you want the SECTBLTPOS to be fixed in place, make three holes in the top of
the table or desk that you want to attach the SECTBLTPOS to.
Tip!
To make sure that the holes are in the right location, place the mounting bracket
on the table or desk and use a pencil to trace the holes in the mounting bracket onto
the desk or table.
4. Line up the holes in the bottom of the mounting bracket with the holes on the top
of the table or desk.
5. Do one of the following:
• If you want to be able to rotate the SECTBLTPOS, insert one of the 5x20 mm
self-tapping screws (
12
) through one of the 15.4x5.0x2.0t flat washers (
13
), the
top hole in the bottom of the mounting bracket, the two 35x1.0t flat washers
(
14
), and into the hole on the top of the table or desk (
figure 12
).
• If you want the SECTBLTPOS to be fixed in place, insert the three 5x20 mm
self-tapping screws (
12
) through the three 15.4x5.0x2.0t flat washers (
13
), the
holes in the bottom of the mounting bracket, and into the holes on the top of
the table or desk (
figure 13
).
6. Tighten as necessary.
