Instruction manual
8
Attach the iPad enclosure to a wall
1. Line up the holes on the mounting bracket with the four holes on the back of the
rear plate (
3
).
2. Use the four M4x8 mm hex screws (
8
) and the 2.5 mm Allen key (
9
) to attach the
mounting bracket to the rear plate.
3. Make three holes in the wall in the location where you want to attach the
SECTBLTPOS.
Tip!
To make sure that the holes are in the right location and are spaced correctly,
hold the mounting bracket up to the wall and use a pencil to trace the holes in the
mounting bracket onto the wall.
4. Line up the holes in the bottom of the mounting bracket with the holes in the wall.
5. Insert the three 5x20 mm self-tapping screws (
12
) through the three 15.4x5.0x2.0t
flat washers (
13
), the holes in the bottom of the mounting bracket, and into the
holes in the wall (
figure 11
).
6. Tighten as necessary.
figure 11
1
12 13
