Starmix NSG Series, Operating Instructions Manual

Page: 36 / 428

36
en
1)
Depending on model
3. Loosen locking screw (J1).
4. Remove filter cartridge (J2).
5. If necessary: Replace gasket (J3).
6. Push new filter cartridge in a straight manner over the case, right up to the stop point (J4).
7. Tighten locking screw (J5).
8. Place cover on the container.
9. Close latches.
Cleaning the submersible pump
See Fig. K.
1. Remove submersible pump (see “Removing the submersible pump”).
2. Insert a suitable tool (e.g. screwdriver) into one of the openings of the suction basket.
3. Lever suction strainer off the pump housing (K1).
4. Clean strainer, impeller and pump housing with a powerful jet of water.
5. Press strainer back onto the pump housing until it engages.
Clean magnetic float:
NOTICE
The encapsulated ring magnet of the magnetic float is fragile!
Damage to the pump due to improper cleaning.
1. Take special care during disassembly, installation and cleaning.
1. Remove slotted plastic disc from the guide tube of the magnetic float.
2. Remove magnetic float from the guide tube.
3. Clean plastic disc, magnetic float, guide tube and float housing.
4. Place magnetic float on the guide tube.
5. Place slotted plastic disc on the guide tube.
6. Ensure that the plastic disc engages fully in the groove of the guide tube.
7. Press strainer back onto the pump housing until it engages.
Clean alarm contact:
NOTICE
Destruction of the alarm contact!
Damage to the pump due to improper cleaning.
1. Do not unscrew the alarm contact for cleaning.
1. Clean surface of alarm contact.
Dispose of filter cartridges, filter bags or disposal bags
Dispose of the filter cartridge, filter bag or disposal bag in accordance with national regulations.
Cleaning
Do not clean the vacuum cleaner with a high pressure cleaner. Only use a wet cloth and mild cleaning agents to
clean it. Acids, acetone and solvents can etch parts of the vacuum cleaner.