Starmix NSG Series, Operating Instructions Manual

Page: 34 / 428

34
en
1)
Depending on model
After work
After sucking up media other than clear water (e.g. liquid containing lime, bitumen or concrete), rinse the
submersible pump with clear water immediately after use.
1. Install drain hose in such a way that escaping water cannot cause any damage.
2. Suck up clear water (e. g. from a bucket) until submersible pump starts.
3. Allow submersible pump to run until no more dirty water escapes from drain hose.
4. Switch vacuum cleaner off, pull mains plug out.
5. Empty container completely and dry.
6. Roll up mains connection cable and suction hose.
Transport and storage
1. Before transport, close the locks on the upper part of the vacuum cleaner.
2. Pay attention to the weight of the vacuum cleaner, particularly if the container is full.
3. Do not tilt the vacuum cleaner if there is liquid in the container.
4. Store the vacuum cleaner dry and indoors, protected from frost.
4 Troubleshooting and repair
Fault Cause Remedy
Suction power drops Lid not properly closed Close lid
Filter dirty Clean
Filter bag full Change
Container full Empty
Motor protection filter blocked Clean
Nozzle, tube or hose blocked Clean
Feed-through of the submersible
pump connection cable not closed
Close feed-through on the
container with the grommet, close
the opening in the grommet with
plug
Water outlet opening on the
container not closed
Close water outlet opening on
the container with Geka-
1)
or
C-coupling
1)
cap.
Sealing ring on elbow union of
water outlet opening is missing or
leaking
Install new sealing ring