4
4
STARLAB Dry Bath Heating Systems
WARNING!
This equipment has been tested and found to comply with the limits for the CE regulation.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at their expense. Changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment. It is strongly recommended that the user reads the following points
before this equipment is operated.
1.
Please read and follow the instructions in this manual.
2. Do not alter the equipment. Failure to adhere to these directions could result in personal
and/or laboratory hazards, and invalidate the warranty.
3. Use a properly grounded electrical outlet of correct voltage and current handing capacity.
4. Disconnect from the power supply before maintenance and servicing. Servicing should
only be carried out by qualified personnel.
5. In the event that solution is accidentally spilled into the instrument, disconnect from the
power supply. You must then carry out appropriate decontamination, for eg. turning
the unit upside down to avoid the solution contacting the internal components. Remove
bottom cover and inspect to assure solution has not contacted elements, thermostat or
connector. Any damaged parts will need replacing.
6. Do not use in the presence of flammable or combustible material; fire or explosion may
result. This device contains components, which may ignite such materials.
7. Ensure that the system is connected to electrical service according to local and national
electrical codes. Failure to properly connect may create a fire or shock hazard.
8. Ensure the appropriate used materials and correct operation to avoid possible hazards
of explosion, implosion or release of toxic or flammable gases arising from the materials
being heated.
9. Always use the supplied handle to remove hot blocks, and wear appropriate protection
to avoid burning your hand.
ATTENTION: Hot surface!
WARNING!
This equipment has been tested and found to comply with the limits for the CE regulation.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at their expense. Changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment. It is strongly recommended that the user reads the following points
before this equipment is operated.
1.
Please read and follow the instructions in this manual.
2.
Do not alter the equipment. Failure to adhere to these directions could result in personal
and / or laboratory hazards, and invalidate the warranty.
3.
Use a properly grounded electrical outlet of correct voltage and current handing capacity.
4.
Disconnect from the power supply before maintenance and servicing. Servicing should
only be carried out by qualified personnel.
5.
In the event that solution is accidentally spilled into the instrument, disconnect from the
power supply. You must then carry out appropriate decontamination, for eg. turning
the unit upside down to avoid the solution contacting the internal components. Remove
bottom cover and inspect to assure solution has not contacted elements, thermostat or
connector. Any damaged parts will need replacing.
6.
Do not use in the presence of flammable or combustible material; fire or explosion may
result. This device contains components, which may ignite such materials.
7.
Ensure that the system is connected to electrical service according to local and national
electrical codes. Failure to properly connect may create a fire or shock hazard.
8.
Ensure the appropriate used materials and correct operation to avoid possible hazards
of explosion, implosion or release of toxic or flammable gases arising from the materials
being heated.
9.
Always use the supplied handle to remove hot blocks, and wear appropriate protection
to avoid burning your hand.
ATTENTION: Hot surface!
