Starke TR-2503, Operation Manual

Page: 9 / 20

GB
S
S
U
U
M
M
M
M
A
A
R
R
Y
Y
The automatic welding mask is a new generation product for labor protection.
Some new and high science and technology such as LCD, optoelectronics
detection, solar power, microelectronics, etc are integrated into it.
The automatic welding mask not only can efficiently protect operator’s eyes from
injuries caused by arc, but also can make both hands free and strike arc
accurately.
Therefore, the quality of products and work efficiency may be raised considerably.
It may be widely used for various welding, cutting, spraying and arc gouging, etc.
W
W
A
A
R
R
N
N
I
I
N
N
G
G
¾
Read and understand all instructions before using.
¾ Be sure that the dark shade of the lens in the welding helmet is the correct
shade number for your application.
¾
This helmets and lenses are not suitable for overhead welding application,
laser welding, or laser cutting applications.
¾
Welding helmets are designed to protect the eyes and face from sparks,
spatter, and harmful radiation under normal welding conditions.
¾
They will not protect against severe impact hazards, including fragmenting
grinding disks, and they must never be used for grinding.
¾
This helmet will not protect against explosive devices or corrosive liquids.
Machine guards or eye splash protection must be used when these hazards
are present.
¾
Impact resistant, primary eye protection, spectacles or goggles that meet
current ANSI specifications, must be worn at all times when using this
welding helmet.
¾
Avoid work positions that could expose unprotected areas of the body to
spark, spatter, and direct and/or reflected radiation. Use adequate
protection if exposure cannot be avoided.
¾
Check for light tightness before each use. Before each use, check that the
protection plates are clean and that no dirt is covering the sensors on the
front of the lens.
¾ Inspect all operating parts before each use for signs of wear or damage. Any
scratched, cracked, or pitted parts should be replaced immediately.
¾
Do not make any modifications to either the welding lens or helmet, other
than those specified in this manual.
¾
Do not use any replacement parts other than those specified in this manual,
unauthorized modifications and replacement parts will void the warranty
and expose the user to the risk of personal injury.
¾
If this lens does not darken when striking arc, stop welding immediately and
contact representative.