2
GENERAL SAFETY INFORMATION
This equipment is designed and sold for commercial use only, and is intended for use by personnel
trained and experienced in its operation. This is not sold for consumer use in and around the home
nor for use directly by the general public in food service locations.
Before using your new equipment, read and understand all the instructions and labels associated
with the unit prior to putting it into operation. Make sure all people associated with its use understand
the units operation and safety before they use the unit.
GENERAL INSTALLATION INFORMATION
The unit is shipped fully assembled and ready to plug into a standard outlet specified for its voltage
and amp draw. If improper electrical supply can be determined through troubleshooting, contact
a qualified electrician prior to using the unit. Removal or replacement of the power cord or plug will
void the warranty. Should you require assistance, contact your local authorized service agent for any
service or required maintenance.
Allow enough space around the toaster for adequate ventilation. Make certain this unit is not located
near other appliances which may produce grease vapor, such as fryers, griddles, etc. In the event this
is unavoidable, ducting will be necessary to supply this unit with an adequate amount of clean, cool
air. It is recommended that you leave at least a one [1] inch (25 mm) gap on each side. Do not operate
the unit without the PTFE sheet and belts properly positioned. If operated improperly, bun sticking
and poor toasting may occur.
Before using the unit for the first time, ensure to clean the toaster properly. Refer to the Cleaning
Procedure document for cleaning instructions.
ELECTRICAL CONNECTION
Before making any electrical connection to this unit, check that the power supply is adequate for
the voltage, amperage, and requirements stated on the rating plate. Make certain to disconnect
the unit from the power source before installing or removing any parts. Be absolutely sure that
the ground connection for the receptacle is properly wired. Do not connect equipment to power
without proper ground connections. Improper grounding may result in personal injury or fatality.
DO NOT CUT OR REMOVE THE PLUG OR
ELECTRICAL REQUIREMENTS
GROUNDING PRONG FROM THE PLUG.
208–240 volts and a NEMA 6-15P
or
CEE7-7
receptacle
are
required
CONNECT/PLUG UNIT INTO DEDICATED
depending on model.
AC LINE ONLY SPECIFIED ON THE DATA
PLATE OF THE UNIT.
DO NOT IMMERSE OR LET THE UNIT STAND
IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE
TABLE/COUNTER IF THE UNIT IS ON THE
TABLE/COUNTER.
KEEP AWAY FROM RUNNING WATER.
6-15P
CEE7-7
