Star Trac E- RB 8110, Owner'S Manual

Page: 10 / 36

110 STAR TRAC E SERIES BIKES OWNER’S MANUAL
A
SSEMBLY AND
S
ETUP
E-UB
UNPACKING
NOTE:
Do not remove the base from the shipping carton at this time.
Remove the top cover from the shipping carton. Remove all parts and shipping supports (except the base) from the carton, and
verify that the following parts are included in your shipment:
Description Qty
Base 1
Display Weldment 1
Neck Tube 1
Seat Tube with Seat and Sleeve 1
Bolt, Allen Head, M8 x 16 mm 4
Description Qty
Washer, M8 4
Bolt, Allen Head, M6 x 65 4
Star Washer, M6 4
Bolt, Allen Head M4 x 20 2
Bolt, M6 x 10 1
This owner’s manual and the warranty card are also included in the packaging.
Note: This manual covers installation of the LED display. If you ordered a PVS kit or an
Embedded Display, please refer to the assembly and operating instructions included with those
products for proper setup and operation of the display assembly.
T
OOLS
R
EQUIRED
Your
STAR TRAC E- UB
can be assembled using the following tools:
„
Metric Hex Key Wrenches
„
Metric Open-End Wrenches
„
Metric Ratchet Socket Wrench Set
„
Torque Wrench
„
Phillips Head Screwdriver
ASSEMBLY
1. Unpack and Position the Base
Cut the long edge of the shipping carton base at both ends. Fold the
flap down to make a ramp.
With the aid of a helper, lift the rear end of the base, and roll the base
off of the shipping carton platform. Place the base on the floor in the
location where the unit will be used. Be sure the chosen location is
level.
2. Install the Neck Tube and Display Weldment
NOTE: You will need someone to assist you to install the display weldment. Have
the person who is assisting you hold the display weldment while you route the
display cables and connect the neck.
Have your helper hold the neck tube close to the base, route the main I/O cable,
auxiliary power and coaxial cable up the full length of the display neck before
seating the neck on the base. See Figure 2a. Secure the neck tube with 4 M8
allen head bolts and washers and torque of 9-11 lbs-ft.
Step 1
Step 2a