Star Micronics TSP1000 Series, Product Specifications Manual

Page: 61 / 66

15-3
15-3-1
Error Specifications
Auto-recovery Error
This error automatically cancels errors by varying the status internally on the printer.
Error LED Cause How to Recover
Power Error
Printing Stops
Because
Detection of
High
Temperature
Head Blink
500msec
OFF Head Thermistor
Temperature Detected (When
detected to be over 60°C) Automatic Recovery when Head Thermistor
Temperature Detected to Drop (When
detected to be under 55°C)
15-3-2 Recoverable Error
This cancels errors while maintaining the printer’s status, by executing a determined error recovery means.
Error LED Cause How to Recover
Power Error
NE Error ON Blink
2000msec
Not enough paper Replace the paper
PE Error ON Blink
500msec
Paper Out Detection Replace the paper
Cover Open
Error ON ON Cover Open Cover Closed
Black mark
Error ON Blink
500msec
Black Mark Paper Size Error
White detected over 400 mm
long Change Black Mark Paper
Adjust Sensor Sensitivity with Sensor
Adjustment Mode
15-3-3 Non-recoverable Error
This error requires the printer to be reset after executing a determined error recovery means because a fatal error has
occurred.
The printer many need to be repaired if the same error occurs even after resetting the printer.
Error LED Cause How to Recover
Power Error
Auto-cutter Error OFF Blink
125msec Cutter Failure Check/repair the cutter
FLASH Access Error
OFF Blink
500msec
FLASH ROM Access Problem Repair
EEPROM Access Error
OFF Blink
750msec
EEPROM Access Problem Repair
SRAM Access Error
OFF Blink
1000msec
SRAM Access Problem Repair
Thermistor error OFF Blink
1500msec Head Thermistor Detected
Erroneous Value Repair
Power voltage error OFF Blink
2000msec Power Voltage Error Value
Detected Check/repair the power supply
TSP1000 Series Product Specifications 15-3