-1-
Mount directly
to mounting
surface
OR
Mount to
enclosed
L-Brackets
5. Slide the mounting bolts to their desired location (usually two bolts towards each end)
and mount the bolts through pre-drilled holes in your vehicle (for direct mounting)
or through the slots in the L-Brackets. Use a flat washer,
split washer, and nut on the bolt. You can mount
the L-Bracket with the base bending towards the
bar
(as pictured below)
or bending away
from the bar.
6. If you are using the L-brackets
provided, use the four
enclosed bolts or
other locally
obtained fasteners
to attach the L-
Brackets to your
mounting surface.
CAUTION: Be sure to carefully inspect and test the integrity of your mount.
Please Note:
These instructions are provided as a general guideline only.
Some
vehicles may require special mounting, wiring, and/or weather-sealing. This is the
sole responsibility of the installer.
Star Headlight & Lantern Co., Inc. assumes no
responsibility for the integrity of the installation for this or any of its products.
1.
Caution
:
There are two vapor vent holes drilled in the bottom of each endcap.
These
are not
visible, so be sure that
the cable exits the left side of the
Traffic Director when you are facing
both the stick and the controller.
Mounting Instructions
274-LLBK
2. Each Traffic Director assembly
comes equipped with two slots
that run along the entire length of
the rear of the extrusion.
The top slot will contain four
¼” x 20 x ¾” hex head bolts
pre-installed.
3. Two “L”-Brackets (274-LLBK) are included
with each traffic director to assist in
mounting.
4. Also included are four flat washers, four split
washers, and four nuts to attach the
L-Brackets to your traffic director.
In addition, there are four ¼” x 20 x ¾” hex
head bolts enclosed that can be optionally
used to mount the L-Brackets to your
mounting surface.
Summary of Contents for TD93-NYDOT
Page 8: ......
