17
4: Storage
Follow the steps below when the vehicle is stored.
1. Check the liquid level inside the battery; recharge it fully before storing
the vehicle.
WARNING:
Charge the battery once a month if your vehicle
will be stored more than one month.
2. Turn the power key to OFF position, remove the key, and store the key in
a safe place.
3. Engage the handbrake.
4. Check the tire pressure to make sure its pressure is set to recommended
pressure.
5. Clean the exterior of the vehicle and apply a rust inhibitor.
6. Cover the vehicle with a breathable cover and store it in a dry, safe, and
well-ventilated place.
7. If you plan to store the vehicle for a longer time, check the liquid level
inside the battery and recharge the battery monthly.
5: Troubleshooting
There is no settled mode to diagnose and eliminate malfunctions. During main-
taining and checking, we suggest you first listen, then look and feel. Below is the
diagnoses and maintenance of some common malfunctions.
1. The vehicle doesn't move after turning on the power key and stepping on accelerator pedal.
Malfunction
Possible Reason
Troubleshooting
Turn on power key,
voltmeter has no signal
Connector(s) in circuit is loose or open
Tighten or connect
Fuse of controller or main circuit is open
Change fuse
Battery cable(s) is loose or disconnected
Tighten of change
Power key is broken
Change
Voltmeter is broken
Change
Battery terminals connect improperly
Adjust
Turn on power key,
voltmeter has signal
Improper operating procedure
Operate properly
Controller failure
Check or change
Solenoid failure
Check, repair, change
Accelerator failure
Repair or change
Motor failure
Repair or change
Parking brake doesn’t loosen
Loosen parking brake
Over-heat protection
Check, eliminate
Summary of Contents for BN72-11-AC-D
Page 21: ...21 6 Electrical Diagrams...
Page 23: ...23...