33
perform remote configuration and password maintenance.
3. Level Three Passwords or Caller IDs are reserved for use by the StarComm Device Management
software. They place the modem in a protocol mode that is required by the device management
software. All modems that will be managed by the StarComm Device Management Software
must contain a Level Three Password.
You may configure password protection to operate either with or without a password prompt. Operating
without a password prompt makes it more difficult for intruders to understand system operation and access
requirements.
AUDIT TRAIL CAPABILITIES –
Models equipped with Password protection or Caller ID protection, also
include facilities for a nonvolatile audit trail with precision date and time recording. When Password
protection is enabled, all successful and unsuccessful attempts to access the modem will be recorded. When
Caller ID protection is enabled, all successful attempts to access the modem will be recorded. As an option,
the telephone number of all unregistered callers may also be recorded. When the audit trail becomes full, it
will automatically wrap around and begin overwriting the oldest entries.
AT\E
- Erase Audit Trail
This command will erase the current contents of the audit trail and initialize it to an empty state.
AT\I+nnnnnnnnnn,l
- Add Caller ID and Level
nnnnnnnnnn = Caller ID (1 – 10 numeric characters)
l = Level (1 = normal, logon only)
(2 = special. Logon + remote configuration)
(3 = for use by Device Management Software)
AT\I-nnnnnnnnnn
- Delete Caller ID
AT\I-*
- Delete All Caller IDs
AT\I?
- Display All Caller IDs
Provides a report of all Caller IDs and levels in the following format:
CALLER ID
LEVEL
nnnnnnnnnn
1
nnnnnnnnnn
2
nnnnnnnnnn
1
AT\O
- Output Audit Trail Report to DTE
When this command is entered, the audit trail will be presented as formatted ASCII output. The format will
contain standard carriage return/line feed control for display on any standard ASCII terminal or terminal
emulator package. Since this command does not erase the contents of the audit trail, it may be executed
repetitively. The report format is as follows:
DATE
TIME
PASSWORD
STATUS
mm/dd/yy
hh:mm:ss
nnnnnnnnnn
APPROVED
mm/dd/yy
hh:mm:ss
nnnnnnnnnn
DENIED
mm/dd/yy
hh:mm:ss
nnnnnnnnnn
APPROVED
