16
16800,14400
2.
<automode> is an optional numeric value which enables or disables automatic modulation
negotiation using V.8 or V.32bis Annex A. The options are:
<automode>
Option Selected
Notes
0
Automode disabled
1
Automode enabled using V.8 or V.32 Annex A
Default
3.
<min rate> is an optional number which specifies the lowest rate at which the modem may establish a
connection. The value is decimal coded in units of bps, e.g. 2400 specifies the lowest rate to be
2400 bps. The default is 300 for 300 bps.
4.
<max rate> is an optional number which specifies the highest rate at which the modem may establish
a connection. The value is decimal coded, in units of bps, e.g. 14400 specifies the highest rate to be
14400 bps. The default is 33600 for 33600 bps.
MNP 10 COMMANDS
)Mn - Enable Cellular Power Level Adjustment
Enables or disables automatic adjustment of the transmit power level to accommodate the signaling
requirements of cellular telephone equipment.
)M0
Disables transmit power level adjustment during MNP10 link negotiation. The )M0 command
allows transmit power adjustment if cellular operation is requested by the remote modem.
Uses wireline power level for initial cellular connection. (Default)
)M1
Enables transmit power level adjustment during MNP10 link negotiation. Uses the @Mn value
to establish initial cellular connection. After connection, the optimal power level is determined
by the modem. NOTE: )M1 should not be used with *H2.
)M2
Enables transmit power level adjustment during MNP10 link negotiation. Uses the @Mn value
to establish initial cellular connection. After connection, the power level remains fixed.
*Hn - Link Negotiation Speed
This command controls the connection speed for link negotiations before upshift occurs between two MNP10
modems.
*H0
Link negotiation occurs at the highest supported speed. (Default)
*H1
Link negotiation occurs at 1200 bps; used primarily for establishing cellular connections.
*H2
Link negotiation occurs at 4800 bps; used primarily to negotiate an MNP10 connection on less
than average quality telephone lines.
-Kn - MNP Extended Services
Enables or disables conversion of a V.42 LAPM connection to an MNP10 connection.
-K0
Disables V.42 LAPM to MNP10 conversion.
-K1
Enables V.42 LAPM to MNP10 conversion. (Default)
-K2
Enables V.42 LAPM to MNP10 conversion; inhibits MNP Extended Services initiation during
V.42 LAPM answer mode detection phase.