18
45- CARRIER 75/1200
46- CARRIER 1200
47- CARRIER 2400
48- CARRIER 4800
49- CARRIER 7200
50- CARRIER 9600
51- CARRIER 12000
52- CARRIER 14400
53- CARRIER 16800
54- CARRIER 19200
55- CARRIER 21600
56- CARRIER 24000
57- CARRIER 26400
58- CARRIER 28800
59- CONNECT 16800
61- CONNECT 21600
62- CONNECT 24000
63- CONNECT 26400
64- CONNECT 28800
66- COMPRESSION: CLASS 5
67- COMPRESSION: V.42 bis
69- COMPRESSION: NONE
70- PROTOCOL: NONE
77- PROTOCOL: LAPM
78- CARRIER 31200
79- CARRIER 33600
80- PROTOCOL: ALT
81- PROTOCOL: ALT-CELLULAR
84- CONNECT 33600
91- CONNECT 31200
S-REGISTERS
The table in this section summarizes the S -Registers and their default values. Registers denoted with (*) may
be stored in one of the two user profiles by entering the &Wn command. One of these profiles may be
loaded at any time by using the Zn command. Registers or register fields quoted as "reserved" are reserved
for current or future use. All bit-mapped registers are read-only. The appropriate AT command which
controls the relevant bits in the S-Register should be used to change the value.
Factory Defaults
The factory default values are stored in ROM and are loaded into the active configuration at power up or by
the ATZn command. In addition, the designated default profile is subsequently loaded, and may change
some of the factory default values. The designated default profile can be changed by entering the &Yn
command where n is one of the two possible use profiles. The factory default values may be loaded at any
time by entering the &Fn command.
S-REGISTER SUMMARY
Register
Function
Range
Units
Saved
Default
S0
Rings to Auto-Answer
0-255
rings
*
0
S1
Ring Counter
0-255
rings
0
S2
Escape Character
0-255
ASCII
*
43
S3
Carriage Return Character
0-127
ASCII
13
S4
Line Feed Character
0-127
ASCII
10
S5
Backspace Character
0-255
ASCII
8
S6
Wait Time for Dial Tone
2-255
s
*
2
S7
Wait Time for Carrier
1-255
s
*
50
S8
Pause Time for Dial Delay
0-255
s
*
2
S9
Carrier Detect Response time
1-255
0.1s
*
6
S10
Carrier Loss Disconnect time
1-255
0.1s
*
14
S11
DTMF Tone Duration
50-255
0.001s
*
95
S12
Escape Prompt Delay
0-255
0.02s
*
50
