V 1.4
8839615
For technical questions call: 1-800-665-8685
22
BRAKES
Failing to properly inspect and maintain the vehicle brake system may lead to loss of vehicle control which can
result in DEATH or INJURY.
•
Avoid aggressive use of the brakes. Apply only moderate braking force for the first 50 stops to allow a break-
in period for the system. Aggressive or overly forceful braking when the brake system is new could damage
brake pads and rotors.
•
ALWAYS check brake operation prior to driving and as per the maintenance schedule. DO NOT OPERATE a
vehicle with brakes that do not operate correctly.
•
Water and freezing temperatures can affect braking performance of the vehicle, check braking performance
after exposure to water, such as after washing or driving through water, and in low temperatures.
•
Brakes must be inspected, cleaned, and replaced if the vehicle is operated in muddy, wet, or sandy
conditions which may cause the brakes to wear faster.
•
Disc brakes should ONLY be serviced and installed by someone competent in the installation and
maintenance of disc brakes.
•
USE DOT 4 Brake fluid when refilling. Do not reuse brake fluid or fluid that has been exposed to air for an
excessive amount of time.
BRAKE TYPE
This vehicle uses three disc brakes for stopping. Each
front wheel has a disc brake, and the rear axle has one
disc brake.
Always check brake pedal travel and the brake fluid
reservoir level before each use of the vehicle. When
applied, the brake pedal should feel firm. Any
sponginess would indicate a possible fluid leak or low
brake fluid level, which must be corrected before riding.
NEVER operate the vehicle with a spongy-feeling
brake pedal which may result in loss of braking,
SEVERE INJURY OR DEATH. Contact your dealer or
a competent brake service provider for proper
diagnosis and repairs if irregularities are found.
FRONT AND REAR BRAKE INSPECTION
1. Operate the brake pedal (Fig. 4) and check for a
spongy feel or excessive travel.
2. Check the front (Fig. 45) and rear disc brake (Fig.
46) calipers for fluid leaks.
3. Inspect the brake cylinder (Fig. 47) located under
the driver’s footwell, hydraulic brake lines, joints,
and hoses for damage, cracks, and leaks.
4. Check the brake fluid level in the brake fluid
reservoir (Fig. 48) located under the driver’s side
seat, if level is at or below the LOWER mark.
5. Check the friction pads for wear, damage and
looseness. The brake pads should be >3/64" (1
mm).
Fig. 45
Fig. 46
Fig. 47
Fig. 48
