Stanley SXAE00125, Manual

Page: 7 / 164

7
2. Connection to the battery
Check first if the negative terminal is connected/grounded to the chassis. If not, contact your
reseller.
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the black
clamp (-) to the earth/chassis of the vehicle (a heavy gauge metal part of the frame or engine
block. Do not connect to the carburetor or fuel lines).
3. Jump Start mode
The green LED on the smart cable turn into solid green, which means that the booster is in
“Ready to Jump Start mode”.
NOTE: Once the LED light is green (solid), you will have 120 seconds to jump start the vehicle.
Otherwise, you need to restart the booster procedure back to step 1.
NOTE: If the vehicle battery is extremely discharged, the initial current draw from the booster
may activate short circuit protection in the smart cable. When the condition is corrected, the
smart cable will automatically reset.
4. Start the engine
Crank the engine for maximum 3 seconds and wait at least 1 minute before a second attempt.
5. Disconnect the output lead
After the engine starts, unplug the battery clamps from the booster socket.
6. Disconnection
Disconnect first the black clamp (-) and then the red clamp (+).
3.2. Starting attempt
When using the booster to start an engine, do not crank for more than 3 seconds , and
wait at least 1 minute before a second attempt.
If the car does not crank a second time, check the smart cable to see if the green LED is lit (solid). If
you hear beeping or an LED is flashing, refer to Troubleshooting.
If no activity is detected, the smart cable will automatically shut off after 120 seconds, and the red and
green LEDs will be solid. Disconnect the booster from the vehicle battery, then restart from Jump
Start Step 1.
NOTE: Cold weather may affect the performance of the booster’s lithium battery. If you hear only a
click and the engine does not turn over, try the following:
With the booster connected to the car battery and the green LED solid on the smart cable, turn on all
lights and electrical accessories for one minute. This draws current from the booster and warms the
battery. Now try to crank the engine. If it does not turn over, repeat the procedure. Extremely cold
weather may require two or three battery warmings before the engine will start.
IMPORTANT: DO NOT attempt to jump start your vehicle more than three consecutive times. If the
vehicle will not start after three attempts, consult a service technician.
3.3. To charge a mobile device, using the USB ports
The booster includes two USB ports. One provides up to 2,1A at 5V DC; the other provides up to 1A
at 5V DC.
1. Consult your mobile device manufacturer for proper charging power specifications. Connect
a mobile device cable to the appropriate USB port.