Stanley FATMAX SCC500, Manual

Page: 10 / 48

10
ENGLISH (Original instructions)
Using the sight guide (Fig. I)
The tool is equipped with a sight guide for straight cutting (21)
and for 45º bevel cutting (22).
● Align the left edge of the guides (21) or (22) with the
cutting line (23).
● Keep the sight guide aligned with the cutting line
while sawing.
● Work with the shoe pressed against the workpiece.
Dust extraction
An adaptor is required to connect a vacuum cleaner or dust
extractor to the tool.
● Insert the dust extraction adaptor into the saw dust
outlet (9).
● Connect the vacuum cleaner hose to the adaptor.
Hints for optimum use
● Always use the appropriate type of saw blade for the
workpiece material and type of cut.
● Always hold the tool with both hands.
● Let the blade run freely for a few seconds before starting
the cut.
● Apply only a gentle pressure to the tool while performing
the cut.
● Work with the shoe pressed against the workpiece.
● As some splintering along the line of cut on the top side of
the workpiece cannot be avoided, cut on the side where
splintering is acceptable.
● Where splintering is to be minimised, e.g. when cutting
laminates, clamp a piece of plywood onto the top of
the workpiece.
● Support large panels to minimize the risk of blade pinching
and kickback. Large panels tend to sag under their
own weight.
● Supports must be placed under the panel on both sides,
near the line of cut and near the edge of the panel
being cut.
● Never hold piece being cut in your hands or across
your leg.
● Secure the workpiece to a stable platform using clamps. It
is important to support the work properly to minimize body
exposure, blade binding, or loss of control.
Accessories
The performance of your tool depends on the accessory
used. STANLEY FATMAX accessories are engineered to high
quality standards and designed to enhance the performance
of your tool. By using these accessories you will get the very
best from your tool.
Maintenance
Your STANLEY FATMAX tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on
the tool, remove the battery from the tool. Unplug
the charger before cleaning it.
● Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
● Regularly clean the motor housing using a damp cloth.
● Do not use any abrasive or solvent-based cleaner.
Protecting the environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
SCC500
Voltage V
DC
18V (20V MAX)
No-load speed Min
-1
4000
Max. depth of cut mm 54
Max depth of cut at 45º bevel mm 45
Blade diameter mm 165
Blade bore mm 20
Blade tip width mm 2.0
Weight kg 3.4
Charger SC125 SC200 SC400
SC401
Input Voltage V
AC
220-240 220-240 220-240
Output Voltage V
DC
18V
(20V MAX)
18V
(20V MAX)
18V
(20V MAX)
Current A 1.25 2 4
Battery SB201 SB202 SB204 SB206
Voltage
V
DC
18V
(20V MAX)
18V
(20V MAX)
18V
(20V MAX)
18V
(20V MAX)
Capacity Ah 1.5 2.0 4.0 6.0
Type Li-Ion Li-Ion Li-Ion Li-Ion