Stanley FATMAX KFMCD628, Original Instructions Manual

Page: 7 / 100

7
ENGLISH (Original instructions)
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
u
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Fat Max Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. Trigger Switch
2. Forward/Reverse Button
3. Torque Adjust Collar
4. Dual Range Gear Selector
5. Keyless Chuck
6. Battery
7. Battery Release Button
8. LED Work Light
9. Bit Tip Holder
Use
Warning! Let the tool work at its own pace.
Do not overload.
Charging the battery
The battery needs to be charged before first use and whenev -
er it fails to produce sufficient power on jobs that were easily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
Note: The charger will not charge a battery if the cell tempera-
ture is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell temperature
warms up or cools down.
u
Plug the charger into an appropriate outlet before inserting
the battery pack.
u
Insert the battery pack into the charger.
The green LED will flash indicating that
the battery is being charged.
The completion of charge is indicated by
the green LED remaining on continuously.
The pack is fully charged and may be
used at this time or left in the charger.
Warning!
Recharge discharged batteries as soon as pos-
sible after use or battery life may be greatly diminished.
Charger diagnostics
This charger is designed to detect certain problems that can
arise with the battery packs or the power source. Problems
are indicated by one LED flashing in different patterns.
Bad Battery
The charger can detect a weak or dam-
aged battery. The red LED flashes in
the pattern indicated on the label. If you
see this bad battery blink pattern, do not
continue to charge the battery. Return it
to a service centre or a collection site for
recycling.
Hot/Cold Pack Delay
When the charger detects a battery that
is excessively hot or excessively cold,
it automatically starts a Hot/Cold Pack
delay, suspending charging until the bat-
tery has normalised. After this happens,
the charger automatically switches to
the Pack Charging mode. This feature
ensures maximum battery life. The red
LED flashes in the pattern indicated on
the label when the Hot/Cold pack delay
is detected.
Problem Power Line
When the charger is used with some
portable power sources such as genera-
tors or sources that convert DC to AC,
the charger may temporarily suspend
operation. The LED flashes in the pattern
indicated on the label. This indicates that
the power source is out of limits..
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefinitely. The charger will keep the battery
pack fresh and fully charged.