4
ENGLISH
(Original instructions)
5
ENGLISH
(Original instructions)
When you notice liquid on the batteries Carefully wipe the
liquid off using a cloth. Avoid skin contact.
u
In case of skin or eye contact, follow the instructions
below.
Warning!
The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
Electrical safety
#
Your adapter is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the adapter
unit with a regular mains plug.
Symbols on Adapter
Short circuit proof safety isolating transformer.
SMPS
$
The charger is intended for indoor use only.
Features
This appliance includes some or all of the following features.
1. Volume buttons
2. Power button
3. Bluetooth
®
/ Auxiliary mode button
4. 18v battery port
5. Auxiliary jack
6. Auxiliary jack holder
Use
Power/Volume Adjustment
To operate as a cordless product, insert a fully charged 18v
Stanley Fat Max battery (not included) into the battery port.
Be sure battery is fully seated.
To turn the speaker on, press the power button (2). Press the
power button again to turn the speaker off.
Press the “+” button (1) to increase the volume. To decrease
the volume, press the “-” button.
Note:
If the battery is attached to the speaker and the AC
adapter is plugged in at the same time, the speaker will run off
of the adapter and not drain the battery. Having both attached
simultaneously will not charge the battery.
Bluetooth
®
and auxiliary function
When the speaker is turned on, it will automatically be in
Bluetooth mode. To switch to auxiliary mode, press and hold
the Bluetooth button (3) until the light turns green. To switch
back to Bluetooth mode, simply press and hold the Bluetooth
button again. The blue light will flash again.
Using Bluetooth® Wireless
Technology*
u
Turn the speaker on.
u
The speaker should already be in Bluetooth mode. If not,
press the Bluetooth button (3).
u
Find “P3BTS” under devices on your Bluetooth enabled
device and select to pair. The blue light will flash while
the pairing takes place. Once the pairing is successful the
blue light will remain steady.
u
Begin playing music on your device.
Note:
The speaker does not have to be in the Bluetooth mode
when pairing, only when listening.
*The Bluetooth
®
word mark and logos are registered trade-
marks owned by Bluetooth SIG, Inc. and any use of such
marks by Stanley Fat Max is under license. Other trademarks
and trade names are those of their respective owners.
Listening in auxiliary mode
To listen to a device in auxiliary mode, press and hold the
Bluetooth button (3) until the blue
light turns green. Plug the auxiliary jack (5) into the auxiliary
port of your device.
When finished, unplug the jack and store it in the auxiliary jack
holder (6).
Incoming Call
If your phone receives a call while it is connected to the
speaker it will ring through the speaker.
Samsung**
To transfer the call to your phone, deselect the headset option
on your phone. The speaker will remain mute until the call is
over. End the call normally with your cell phone. The speaker
will resume previous function.
**Samsung® is a registered trademarks of Samsung Group.
iPhone
®
***
To transfer the call to your phone, select “audio source” on
your phone, then select “iPhone.” The speaker will remain
mute until the call is over. End the call normally with your cell
phone. The speaker will resume previous function.
