Stanley Avdel 73200, Instruction And Service Manual, Page: 14 / 96

5.1 INSTALLATION INSTRUCTIONS
BODY DISASSEMBLY
•
To fit these collar splitters, disconnect tool from air supply
• Remove pin tail deflector
47
.
• Remove nose assembly, if fitted
• Lubricate the collar splitter cam faces, bearing faces and any
moving parts with Moly Lithium Grease.
• Holding the head piston with a 10mm A/F” Allen Key through
the back of the tool, tighten the collet adaptor onto the head
piston with a spanner.
• Push the anvil adaptor over the collet adaptor and screw on.
Tighten with a spanner
• Insert the assembled collar splitter into the anvil adaptor and
screw onto the end of the collet adaptor. Tighten the nose
retaining nut on the anvil adaptor with a spanner
• To operate, push the collar splitter hard over the collar and
depress the trigger.
• To cut 5/16” or 3/8” Avdelok® use 07220-03700 and 07220-03900 collar splitters respectively – no adaptor kit is required.
• Fit Head Vice Jaw* to Head
63
and use soft jaws to hold the Head Vice Jaw in the inverted orientation.
• Use Locknut Socket* to unscrew Locknut 38 . If necessary, use a 10mm A/F Allen key to prevent rotation of Base Plate
32 .
• Remove Base Cap
31
and Gasket
36
.
• Remove Retaining Ring 25 and Silencer 37 .
• Push Base Plate
32
into Body
65
and remove Retaining Ring
24
.
• With Base Plate extractor* fitted to underside of Body 65 , screw Locknut 38 onto Base Plate 32 , extracting Base Plate
from Body. If necessary, use a 10mm A/F Allen key to prevent rotation of Base Plate.
• Screw Piston Stop to underside of Air Piston
33
locate using M6 screws into base and screw on.
* Contained in Service Kit. For complete list see page 17.
It is necessary to remove these accessories for priming of the tool.
-
14
ENGLISH ORIGINAL INSTRUC TION