Assembly Instructions:
•
Clean all the parts thoroughly. Inspect and replace any parts that are worn or damaged.
•
Assembly is the reverse procedure for dismantling.
•
Ensure that the seals (Items 4 & 5) and the wiper (Item 3), are replaced in the correct orientation. Lubricate all seals and
housings, with Molylithium Grease (07992-00020).
•
When fitting the piston (Item 14) into the body (Item 13), it is essential that the assembly bullet 07900-00735 is used to
prevent seal damage.
•
The jaw spreader housing assembly (Item 11) must be screwed onto the piston (Item 14) to a torque of 27 NM (20lbsf ft).
All item numbers refer to the General Assembly and Part List in section 6.0.
5.7 PROTECTING THE ENVIRONMENT
•
Assure conformity with applicable disposal regulations. Dispose all waste products at an approved waste facility or site
so as not to expose personnel and the environment to hazards.
10
ENGLISH
ORIGINAL INSTRUC TION
