Stanley 309311x692A, Instruction Book

Page: 23 / 64

GB
23
F–030601L
9. To operate without the mower housing, move
the lift lever to the TOP position.
10.To install the mower housing, reverse the
above steps.
11. Make sure the mower drive belt (7) is inside
all the belt guides (10) and is also below the
spacer tube (11).
How To Install The Wheels
If the wheels must be removed for service, make
sure they are installed as follows:
Front Wheel (Figure 24)
1. Make sure the valve stem (2) is to the out-
side. Slide the front wheel (1) onto the
spindle (3).
2. Fasten the front wheel (1) with washers (4)
and cotter pin (5). Bend the ends of the
cotter pin (5) apart to keep the front wheel
(1) on the spindle (3).
3. If your model has hub caps (6) , install the
hub caps (6) . Make sure the washers (4)
hold the hub caps (6) in place.
Rear Wheel (Figure 25)
1. Install the washers (7) and spacer (8) onto
the axle (9) .
2. Mount the square key (10) in the key slot
(11) .
3. Make sure the valve stem (2) is to the out-
side. Align the slot in the rear wheel (12)
with the square key (10) . Slide the rear
wheel (12) on the axle (9) .
4. Fasten the rear wheel (12) with washer (7)
and e–ring (13) .
5. If your model has hub caps (6) , install the
hub caps (6) . Make sure the washer (7)
holds the hub caps (6) in place.
How To Replace The Fuse
If the fuse is blown, the engine will not start.
Remove the fuse and replace with a 15 amp.
automotive fuse.
Storage (over 30 days)
At the end of each year, prepare the unit for stor-
age as follows.
1. Drain the fuel from the carburettor and the
fuel tank. Change the engine oil. See the en-
gine manufacturer’s instructions.
2. Clean the entire unit.
3. Charge the battery.
How To Order Replacement Parts
The replacement parts are shown either on the
back pages of this Instruction Book or in a sep-
arate Parts List Book.
Use only manufacturer’s authorized or approved
replacement parts. The letter placed on the end
of the part number denotes the type of finish for
the part, C for chrome, Z for zinc, a PA for pur-
chased assembly. It is important that you include
this when ordering a part. Do not use attach-
ments or accessories not specifically recom-
mended for this unit. In order to obtain proper
replacement parts you must supply the model
number of your mower (see nameplate).
Replacement parts, except for the engine, trans-
mission, transaxle or differential, are available
from the store where the mower was purchased
or a service shop recommended by the store.
If you are unable to obtain parts or service in the
manner outlined above, then contact:
Stanley Outdoor Power Equipment
Customer Service Department
PO Box 268
Brentwood, TN 37024–0268
1–800–788–7766
www.stanleylawnmowers.com
Replacement parts for the engine, transaxle, or
transmission, are available from the manufac-
turer’s authorized service center found in the
commercial pages of the telephone directory.
Also, see the individual engine or transmission
warranties to order replacement parts.
When ordering the following information is re-
quired:
(1) The Model Number
(2) Serial Number
(3) Part Number
(4) Quantity