Stanford Research Systems
PS300 Series High Voltage Power Supplies
Instrument Overview
1 – 5
The two MONITOR output BNCs are used to monitor the voltage
and current signals. Both are 0 to +10 V outputs corresponding to
0 to full scale. The
SET
input BNC receives an analog programming
voltage, 0 to +10 VDC corresponding to 0 to full scale (independent
of high voltage polarity). To select the rear
SET
analog high voltage
control, press [SELECT] on the front panel until
REAR
is selected,
and then use the [
▲
] and [
▼
] keys to choose between “Front” and
“Rear”. Press [ENTER] to con
fi
rm the selection.
The 24-pin IEEE-488 (GPIB) connector allows computer control of
PS300 series supplies. The address is set from the front panel using
the [GPIB] key.
The 9-pin female D-sub connector allows computer control of
power supply via RS-232. The interface se ings are
fi
xed as DCE,
9600 baud, no parity, 8 bits, 1 stop bit.
1.2.3 Analog I/O
1.2.4 IEEE-488 Port
1.2.5 RS-232 Port
Summary of Contents for PS355
