Standard Horizon GX2000E, Owner'S Manual

Page: 57 / 128

Page 57 GX2000E/GX2100E
3. Press the [ SELECT
] soft key. The transceiver will
beep, and the “Last Individual Call” will appear.
4. Press the [ NEW ID
] soft key, then select “
MANUAL
”
with the CHANNEL knob.
5. Press the [ SELECT
] soft key.
6. Rotate the CHANNEL knob to select the first num-
ber of the MMSI which you want to contact, then
press the [
SELECT
] soft key to step to the next num-
ber.
7. Repeat step 6 to set the MMSI number (nine digits).
8. If a mistake was made entering in the MMSI num-
ber, repeat pressing the [ BACK
] key until the wrong
number is selected, then rotate the CHANNEL knob
to correct the entry.
9. When finished entering the MMSI number, press and
hold the [ SELECT
] soft key.
10. Press the [ SELECT
] soft key, then rotate the
CHAN-
NEL knob to select the operating channel you want
to communicate on, then press the [ SELECT
] soft
key. If the channel is not shown in the list, press the
[
MANUAL
] soft key, then rotate the
CHANNEL knob
to select the operating channel you want to com-
municate on, then press the [
SELECT
] soft key.
11. Press the [ YES
] soft key to transmit the individual
DSC signal.
12. When an individual call acknowledgment is received,
the established channel is automatically changed
to the channel which is selected on step 5 above
and a ringing tone sounds.
13. Press the [ QUIT
] soft key to listen to the channel to
make sure it is not busy, then press the microphone’s
PTT switch and talk into the microphone to the other
vessel.