5
Electrical Hook-up
WARNING:
Never Connect or disconnect electrical cables with power on.
CAUTION:
It is recommended that electrical connections be performed by a qualified
electrician and that you should check local building codes for compliance.
The MC Changer cabinet comes pre-wired*. The changer need only be connected to a
properly grounded electrical outlet. (3
rd
wire ground back to main service panel) We also
recommend that the changer be wired on a dedicated line. A dedicated line is a circuit
which has no other equipment connected on the same circuit breaker or fuse. The
purpose of a dedicated line is to reduce the possibility of line interference, which may
cause the changer to malfunction. Some models have several cut outs allowing alternate
wiring inlets. For outdoor locations permanent wiring is required. (See instructions
below.)
Important Note:
NOTE:
TEMPORARY HOOKUPS: never allow access to the power plugs. Power
cable feed should not exceed 100 Feet in length.
NOTE
: An improperly connected machine may void your warranty.
* NOTE:
Permanent outdoor installations require the use of watertight conduit if the
supply line would be exposed to the weather.
WARNING!!!
Welding the cabinet to any kind of mounting could cause damage to electrical components
within the machine! Warping of the cabinet may also occur. Welding of any kind to the cabinet
during installation will void the manufacturer’s warranty!
If welding is ultimately necessary, all components within the machine must be removed prior
to welding! Please contact our Service Department with any questions.
