4
For rear load changers it may be necessary to temporally remove the power cord to make
installation of the cabinet easier. Cover or remove the hoppers to prevent debris or metal
shavings from falling into the hopper mechanisms. To remove the cord, locate the cord
retaining plate on the inside of the changer cabinet. Remove the two nuts securing the
cord to the inside of the changer. Pull the cord into the inside of the changer. After
installing the cabinet, reverse the directions above to return the cord to its correct
location.
For Outdoor locations
Use either silicone or RTV caulking for a watertight fitting. Place a large continuous
bead of caulking on the backside of the front plate around the changer cabinet and fill gap
around the faceplate to cabinet joint so that when the changer is slid through the wall
opening a tight weather poof seal is formed.
Any deviation of these guidelines will void the machine’s warranty.
Installing Stand Mounted Changers
Stand mounted changers can be mounted in between or with other vending machines.
Optional cap kits are available to make the changer the same height as other vending
machines. The changer is bolted to the stand (four mounting holes) and the stand can be
bolted to the floor (four mounting holes) or to the wall for maximum security and safety.
A floor template is included with the stand.
WARNING:
CHANGERS MOUNTED ON THE BASES ARE TOP HEAVY. The
changer must be secured to a rigid vertical surface, as well as to the stand to provide
appropriate security, stability, and safety.
Figure 2
Angle Iron to Secure
Cabinet Sides
Steel Shelf with
Steel Support Poles
Angle Iron to Secure
Cabinet Sides
CINDER BLOCK WALL
2 x 4 WALL