ASSEMBLY INSTRUCTIONS
8
STEP 5
Attach the
FOOTREST(8)
onto the
HEIGHT ADJUSTMENT BEAM(6)
with the
ADJUSTMENT KNOB(9).
NOTE:
STEP 6
Insert the
PAD TUBE(10)
through the hole on the
HEIGHT ADJUSTMENT BEAM(6)
and secure with
HEX
BOLT(M6x1x47mm)(40),
NYLOCK NUT(M6x1)(42),
and
WASHERS(M6)(45).
Place a
HEEL HOLDER
BRACKET(11)
onto a
HEEL HOLDER(12),
then slide them onto
PAD TUBE(10)
together. Slide another
set of
HEEL HOLDER BRACKET(11)
and
HEEL HOLDER(12)
onto the other end of the
PAD TUBE(10).
STEP 7
Attach the
ADJUSTABLE INSTEP FRAME(7)
to the
HEIGHT ADJUSTMENT BEAM(6)
by pulling the
SMALL
SPRING PIN(15)
and sliding the
ADJUSTABLE INSTEP FRAME(7)
completely into the
HEIGHT
ADJUSTMENT BEAM(6).
Place a
WASHER(M6)(45)
onto the
HEX BOLT(M6x1x47mm)(40),
then insert
the bolt the halfway through the square tube on the
HEIGHT ADJUSTMENT BEAM(6),
slide the bolt through
the ring at the bottom of the
SPRING(13),
slide the bolt through the square tube and secure with
NYLOCK
NUT(M6x1)(42)
and
WASHER(M6)(45).
Press the
SQUARE PLUG(35)
into the
HEIGHT ADJUSTMENT
BEAM(6).
Slide the
FOAM PADS(31)
onto both sides of the
ADJUSTABLE INSTEP FRAME(7).
The four adjustment holes in the
FOOTREST(8)
allow the
FOOTREST(8)
to be atta ched in four
different positions. Start with one of the center position s and adjust if necessary. Use the higher
position holes if users are taller than average. Use the lower position holes if users are shorter than
average.
Summary of Contents for 55-1532A
Page 14: ...PRODUCT PARTS DRAWING BACK FRONT 14...
Page 17: ...NOTES 17...
