ASSEMBLY INSTRUCTIONS
8
STEP 3
Remove the
BUMPER(45)
from the
RAIL(1).
Slide the
SEAT(54)
onto the
RAIL(1).
Bolt the
BUMPER(45)
back to the
RAIL(1).
NOTE:
Roller
1. Refer to the inset drawing. If it is difficult to slide the
SEAT(54)
onto the
RAIL(1),
turn the
NYLOCK
NUTS(M6)(78)
located on both sides of the
SEAT CARRIAGE(55)
counterclockwise to lower
the position of the Roller.
2. If the
SEAT(54)
rocks after sliding it onto the
RAIL(1),
then turn the
NYLOCK NUTS(M6)(78)
located on both sides of the
SEAT CARRIAGE(55)
clockwise to raise the position of the Roller
to tighten it up to the
RAIL(1)
.
