1. If your heart rate is inconsistent or not tracking on your workout monitor, do the following:
The
HEART RATE TRANSMITTER(106)
will connect to your device while using the unit and within 10
feet of close proximity to your device. If you are too far from your device the connection will be lost.
Moisten the h
eart rate
sensor electrodes on the back of the
ELASTIC SENSOR STRAP(107)
and
make sure they are in contact with the skin. Your skin may be dry when you begin your workout and
the moisture is necessary to ensure contact. As you sweat, contact will improve.
Tighten the elastic strap so it remains in place as you exercise. Movement of the h
eart rate
sensor
electrodes will result in inaccurate or erratic signal and readings.
Body hair affects the detection and transmission of heart rate signals. If necessary, trim or shave chest
hair so that the h
eart rate
sensor electrodes touch the skin.
Clean the h
eart rate
sensor electrodes as dirt can interfere with transmission. Use a mild soap and
water and dry with a soft towel.
Wash regularly with mild soap and water solution and dry with a soft towel being careful not to scratch
the h
eart rate
sensor electrodes.
Store in a cool, dry place. Make sure the h
eart rate
sensor electrodes aren
’
t stored with any wet material
and never store a wet transmitter in non-breathable material like a plastic bag or sports bag.
Do not stretch the h
eart rate
sensor electrodes.
Transmitter Care and Maintenance
OPERATIONAL INSTRUCTIONS
NOTE:
The frequency of the Bluetooth
HEART RATE TRANSMITTER(106)
is 2.4 GHz. All compatible
heart rate transmitters from other companies will work with the
SMART MOUNT(45)
.
To wear the
HEART RATE TRANSMITTER(106)
around the chest, make the red LED indicator on the
HEART
RATE TRANSMITTER(106)
upward. Attach the clasp end of the
ELASTIC SENSOR STRAP(107)
to the
loop end of the
ELASTIC SENSOR STRAP(107),
and adjust the
ELASTIC SENSOR STRAP(107)
to
fit your chest snugly as shown in the illustration below. Apply water or conductive gel to moisten the h
eart
rate
sensor electrodes. These h
eart rate
sensor electrodes must be wet and in contact with your chest skin
to properly detect your heart rate.
(107)Elastic Sensor Strap
(107)Elastic Sensor Strap
Clasp
21
OPERATION DESCRIPTIONS
2. A
lways make sure to pair the
HEART RATE TRANSMITTER(106)
with your device in the
müüv app
via Bluetooth. If the
HEART RATE TRANSMITTER(106)
has been paired with your device, not in the
müüv app,
please remove the pairing from your device, then redo the pairing in the
müüv app.
3.
Avoid using the
HEART RATE TRANSMITTER(106)
at temperatures below -10ºC (14ºF), as this will
slow down the display of heart rate readings.
4. The
HEART RATE TRANSMITTER(106)
is not a medical device, nor intended for medical diagnostic
purposes. Maintaining a consistent signal can be difficult due to the moving during riding the bike. The
pulse function is a great tool to optimize your workout, but should be used as a reference only.
T h e r e d L E D i n d i c a t o r o n t h e
H E A R T R AT E
TRANSMITTER(106)
will flashing when detected active
pulse. Automatically shut off after five minutes of inactivity.
Loop End
LED Indicator
Upward
