OPERATIONAL INSTRUCTIONS
12
SEAT ADJUSTMENT
CAUTION:
1. Turn the
ADJUSTMENT KNOB(41)
to loosen, then pull
the
ADJUSTMENT KNOB(41)
to release the pin. Slide
the
SEAT FRAME(5)
until the
SEAT(43)
is at the proper
height. Release the
ADJUSTMENT KNOB(41)
making
sure the pin catches in one of the holes of the
SEAT
FRAME(5)
and tighten the
ADJUSTMENT KNOB(41).
Proper seat adjustment is important.
1. Do not attempt to adjust the seat while you are on the
INTONE® Folding
Cycle Pro
.
2. Always tighten the
ADJUSTMENT KNOB(41)
after
adjusting the seat to a new position.
To increase the load, turn the
TENSION KNOB(25)
clockwise.
To decrease the load, turn the
TENSION KNOB(25)
counterclockwise.
LOAD ADJUSTMENT
2. Sit on the seat and place your feet on the pedals. You
should be able to move through a complete pedal stroke
without locking your knees or shifting your hips on the
seat. The seat is too close to the pedals if you have more
than a slight bend in your knees at the bottom of the pedal
stroke. The seat is too far from the pedals if you have
to completely straighten your knees at the bottom of the
pedal stroke. Refer to the illustration.
The safety and integrity designed into the
INTONE® Folding
Cycle Pro
can only be maintained when the
INTONE® Folding
Cycle Pro
is regularly examined for damage and wear. Special attention should be
given to the following:
1. Adjust the
TENSION KNOB(25)
and verify that the Magnetic System provides tension. The Magnetic
System should provide many years of use.
2. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
3. Verify that the
WARNING LABEL(75)
is in place and easy to read. Call Stamina Products immediately
at
1-800-375-7520
for a replacement
WARNING LABEL(75)
if it is missing or damaged.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the
INTONE® Folding
Cycle Pro
removed from service until repair is made.
6. Only Stamina Products supplied components shall be used to maintain/repair the
INTONE® Folding
Cycle Pro
.
7. Keep your
INTONE® Folding
Cycle Pro
clean by wiping it off with an absorbent cloth after use.
MAINTENANCE
Summary of Contents for 15-0201
Page 16: ...PRODUCT PARTS DRAWING 16 FRONT BACK ...
Page 20: ...NOTES 20 ...
Page 21: ...NOTES 21 ...