Cleaning
16
Proceed as follows:
Remove the two plugs using a sharp object.
Retain the plugs for later use.
To adjust the lower end of the range, insert the
Allen key in the hole nearer to the handle.
To adjust the lower end of the range, insert the
Allen key in the other hole.
Turn the Allen key with great care and very
slowly. Turning in a clockwise direction increases
the cut-out torque level, turning in the other
direction decreases it. The screws will lock in any
position.
Once you have made an adjustment using one
screw, check the effect by testing the cut-out
value on the torque tester.
Repeat the adjustment of one or both screws and
the testing process until the deviation has been
compensated.
Finally, do a thorough test again. Proceed as
described under „Checking the accuracy of the
cut-out value“.
If you cannot achieve adequate correspondence
between the triggering values and the set values in
this way, the triggering mechanism is probably
defective.
Consult STAHLWILLE if this occurs.
Replace the plugs as appropriate to protect the
cut-out mechanism against dirt and damp.
Replacement plugs are available from
STAHLWILLE.
Cleaning
Clean the MANOSKOP
®
only with white Spirit.
Other chemical substances may damage the plastic
components.
