Operation
10
If you are using a ratchet insert tool, set this to the
desired direction by turning the control knob.
Removing insert tools
730/5 to 730/65 Quick
If the tool was attached in the „normal“ position,
press the release button on the underside of the
head of the wrench.
If the tool was attached to the torque wrench
rotated through 180°. Insert a fine punch into the
locating hole in the head of the wrench. Use the
punch to depress the locking pin.
Extract the insert tool.
Setting the torque level
The torque level at which the wrench cuts out is set
by moving the scale against the fixed mark. Always
approach the desired torque setting from a lower
value. Intermediate settings between two marks on
the scale can be estimated.
In order to be able to set the scale, the setting fail-
safe mechanism has to be operated first. Once the
setting fail-safe mechanism is released, the value
set is automatically locked.
Proceed as follows:
Hold down the pressure plate at the grip end to
release the setting lock.
Slide the scale to a torque level lower than the
desired cut-out value.
Slide the scale to the desired cut-out value. The
integrated magnifying glass helps you to position
the scale precisely.
