Operation
11
Release the pressure plate again.
The set value is now safely locked.
Check the set value once again. If the set value is
wrong, repeat the process.
Controlled counter clockwise tightening
Due to reasons of accuracy, the torque wrenches
only function in one direction. This is identified by
an arrow and the word "CLICK".
Controlled counter clockwise tightening is possible
by turning the MANOSKOP
®
over. Exceptions: The
MANOSKOP
®
721/5, 721/15 and 721/20 Quick
cannot be used for counter clockwise tightening.
Counterclockwise tightening is possible with the
MANOSKOP
®
721/30 Quick by means of a square
drive which is pushed through.
For controlled counter clockwise tightening using
the MANOSKOP
®
721/30 Quick in the turned over
position, the square drive must first be pushed
through to the upper side. For controlled counter
clockwise tightening using the MANOSKOP
®
730/5
to 730/65 Quick, the insert tool has to be rotated
through 180°. Ratchet insert tools also need
switching to „L“ (CCW) for the correct tightening
direction.
Uncontrolled loosening of nuts & bolts
...
... opposite to the tightening direction is possible.
The cut-out mechanism is not placed under load
during this process.
ATTENTION!
Exceeding the limit torque leads to the
risk of the torque wrench becoming
damaged.
Make sure that a limit torque of
approx. 125 % of the maximum scale
value is not exceeded.
Do not loosen any tightly rusted bolts
using the torque wrench.
