Stahl EC-940-AFZ Series, Owner'S Manual And Operating Instructions

Page: 15 / 40

Manual / Operating Instructions EC-940 Safety Advice

R. STAHL Camera Systems GmbH / HM_OI_Camera_EC_940_en_V_01_00_04.docx / 23.07.2018 Page 15 of 40
10 Safety Advice
This chapter is a summary of the key safety measures. The
summary is supplementary to existing rules which staff also have to
study.
The safety of persons and equipment in hazardous areas depends
on compliance with all relevant safety regulations. Thus, the
installation and maintenance staff carry a particular responsibility,
requiring precise knowledge of the applicable regulations and
conditions. Requiring precise knowledge of the applicable
regulations and conditions.
The notes listed below in section 10.1 must be heeded to avoid injury
and damage to equipment !
10.1 Installation and operation
Please note the following when installing and operating the device:

The national regulations for installation and assembly apply (e.g. IEC/EN 60079-14).

The EC-940-AFZ cameras may be installed in zones 1 or 2 and 21 or 22.

The camera must not be opened while connected to power.

The camera must not be connected whilst switched on.

The camera must be switched off before it is disconnected from the cable / connected
system.

The camera's power supply or its main circuits must be safely grounded.

Before switching on the EC-940-AFZ camera ensure that the mechanical and electrical
connections of all components fit securely.

National safety and accident prevention rules.

Generally accepted technical rules.

Safety instructions of this manual / these operating instructions.

Any damage may compromise the explosion protection !
Use the EC-940-AFZ cameras for their intended purpose only (see "Camera Function").
Incorrect or unauthorized use and non-compliance with the instructions in this manual / these
operating instructions will void any warranty on our part.
No changes may be made to the EC-940-AFZ camera or one of its components that
compromise explosion protection !
The camera may only be installed and operated in an undamaged, dry and clean condition !
NOTICE
CAUTION