FRONT PANEL:
This PA System includes a 4-Channel, 2x75 W RMS/ 4 Ohms, Powered Mixer w/ Digital
Reverb (PA4/200) or w/ Digital Signal Processor (PA4/200 DSP) and two 2-way, 150W/ 4
Ohms Speaker Cabinets.
INPUT SECTION FEATURES – CHANNEL 1 to 4
1) MIC IN:
This low impedance, 3-pin XLR input socket is for connecting balanced, low impedance
microphones. Input impedance is 1k Ohm. The connector is wired as: Pin 1 = shield; Pin 2 = positive (hot);
Pin 3 = negative (cold).
2) LINE:
This high impedance, line level, 1/4” jack input socket may be used either with high impedance
microphones or with devices such as Tape/CD/MP3 players, effect returns or radios. You may also connect
an electric guitar, bass, or keyboard. This is a 2-conductor input with an impedance of 10k Ohms. Both high
& low impedance inputs may be used simultaneously.
3) VOLUME
: This is the independent volume control for each channel. The signal is sent to the master
section. Typical setting is between 4 and 8, depending on the channel’s function. Please note that this
volume control acts as a preamp, so if the channel is being used for a device that has a volume output
control (e.g.: CD or Tape player), some level matching by adjusting the level controls on each unit will be
required.
4) TREBLE:
This is the independent treble control to adjust the level of high frequencies in the output
signal on both inputs of each channel.
5) BASS:
This is the independent bass control to adjust the level of low frequencies in the output signal
on both inputs of each channel.
6) EFF:
This control is used to set the level of the internal effect (Digital Reverb on PA4/200 and Digital
Sound Processor on PA4/200 DSP) blended in to the input signals of each channel.
MASTER SECTION FEATURES
1) EQUALIZATION:
- BASS:
This controls the overall amount of low frequencies (@ 50 Hz), al/- 15 dB of boost or cut.
- MIDDLE:
This controls the overall amount of middle frequencies (@ 2 kHz), al/- 12 dB of boost or cut.
- TREBLE:
This controls the overall amount of high frequencies (@ 10 kHz), al/- 15 dB of boost or cut.
2) CD/ TAPE:
This controls the overall level of any CD or Tape player connected to the apparatus via the
CD/Tape inputs on the rear panel.
3) EFF RETURN:
This controls the signal output level of the internal effect (Digital Reverb on PA4/200 and
Digital Sound Processor on PA4/200 DSP) mixed to the direct signal coming from the master EQ output.
4) MASTER:
This is the master volume which controls the overall volume level of the unit.
5) DSP EFFECT (PA4/200 DSP only):
This selector enables the user to choose among 16 internal DSP
effects, including 8 Reverb effects, 3 x Chorus, 1 x Flanger, 2 x Delay, 1 x Vocal Mute & 1 x «Rotating
speaker» effect.
6) EFF SEND (PA4/200 DSP only):
This controls the amount of the output signal from the internal
DSP effect.
7) POWER LED (PA4/200 DSP only):
When this red LED is lit, the powered mixer is ready to work.
When it is unlit, it means the apparatus is powered off.
3
USER MANUAL
PA4/200 USA & PA4/200 DSP USA
