5
USER MANUAL
BACK PANEL:
WARNING:
This device must be earthed. Please check that the supply voltage details given on the rating
label (located on the rear panel) are in accordance with your electricity supply.
1) POWER:
This switch turns the powered mixer on or off. The switch is illuminated when the device is
powered on. On PA4/200 models, this switch is located on the FRONT PANEL.
2) MAINS:
This is the input socket into which the mains power cable must be connected. This powered
mixer is supplied with a power cable with a moulded-on plug. If the socket outlets in the home are not
suitable for the plug supplied with this device, use an appropriate plug adapter that can handle the power
required for this powered mixer.
3) FUSE:
In the event of the power fuse having to be replaced, first unplug the power cable from the
mains outlet. Then remove the fuse cover and replace the power fuse with one of the same type and value.
Never plug the power cable back into the mains outlet without the fuse cover. If, when powering on the
device, the power fuse blows up again, go to a suitable service centre for repair.
4) VOLTAGE SELECT:
This switch selects the chosen voltage level between 120VAC and 230VAC as
appropriate. This switch may be accessed by unscrewing the safety cover. Always make sure that the
selected voltage level is in accordance with your electricity supply.
5) CD/TAPE IN:
These are two line level Phono/Cinch inputs into which a CD/Tape/MP3 player may be
connected. Please note that both L and R inputs must be used in order for the sound to be reproduced
in full.
6) EFFECT SEND:
This PA system is equipped with an effects loop which allows you to plug outboard
effects or EQ systems between the preamp and the power amp. The SEND jack is a line level
1/4” (Ø 6,3 mm) output jack into which you may connect one or several outboard effects, eg Flanger,
Compressor, Pitch-shift, Chorus etc. The SEND jack should be connected to the input jack of the first effect
in your effects chain.
7) EFFECT RETURN:
This is a line level input jack to which you should connect the output jack of the
last effect in your effects chain. The effects loop may also be used with a multi-effects rack system, or
with a single effect.
8) SPEAKER OUT 1 & 2:
These are 4 Ohm 1/4” output jacks into which you may connect the two speaker
cabinets included in the set, or any two speaker cabinets w/ a minimum impedance of 4 Ohms and a
minimum power handling of 120 W RMS PER SPEAKER.
PA4/200 USA & PA4/200 DSP USA
