5.2. Electric starting
1.
Starting
(The preparations for electric starting are the same as for the recoil starting.)
•
Open the fuel cock.
•
Set the engine speed lever at "RUN" position.
•
Turn the starting key clockwise to "START" position.
Remove your hand from the key as soon as the engine starts. If
the starting motor does not start after 10 seconds, wait 15
seconds before starting it again.
CAUTION
•
Running the starting motor for long time will cost the battery power greatly even burn out the motor.
•
Always leave the starting key at "ON" position while the engine is running.
•
Battery power will be greatly consumed while engine preheating. Do adjust the preheating time per real time
ambient.
2.
Battery:
Check the battery voltage before starting generator set every time.
5.3 Digital control panel (optional for some models)
Starting power
: Power switch of genset control system.
Communication port
: ATS connector
Emergency stop knob
: Only for shut down the genset under
emergency situation.
AC output switch
: Load switch for voltage output of genset.
Receptacle
: AC type.
Digital controller
: There’s real time running data of genset. Do refer
to controller manuals for detailed information.
Ver. 3/Rev. 1; Data: 03.02.2022;
43
Summary of Contents for YDE6500E
