There're rotating parts, high temperature parts and high voltage parts inside genset. Do close the
service door before running.
•
Check engine oil
(1) Check oil level with oil stick.
(2) Do add oil in case oil level is below than the bottom line of oil stick.
(3) Check the oil is clean of not.
•
Check fuel
Check fuel level and refuel in case.
Check the fuel filter and fuel line is good and clear. Otherwise they must be replaced.
Do clean the fuel tank regularly.
•
Earth
: The canopy and load must be earthed.
•
Check oil/fuel leakage
: Open service door to check oil/fuel leakage. If there’s leakage, do
check and repair before starting.
•
Check bolts and nuts
: Check all bolts and nuts must be tightened. Do pay special attention
to the air filter, muffler and flywheel generator bolts and nuts.
•
Clean the genset
Check the interior of genset to see whether there’s tools or other things inside and do clean in
case.
Check the muffler and engine to make sure the surrounding of those parts is clean. Make sure the
air inlet and exhaust is smooth.
WARNING
•
Do inspection and service after the genset is completely stopped.
•
Do earth the genset to prevent it from electrical shock.
•
Do disconnect the load before inspection or service to avoid the accident due to sudden load running while
starting genset.
•
Check battery
a)
Check battery voltage before starting. In case the voltage is lower than 12V, do recharge
the battery. Otherwise it will be difficult to start the engine and cause the starting motor
damaged.
b)
In case the genset powered with battery charger will be store for long time, do disconnect
the battery negative wiring and charge battery every 30days.
c)
Do disconnect battery negative wiring before inspection and service. Don’t disconnect
battery wiring while genset is running.
d)
The battery is service free type. There’s ethereal sulphate inside electrolyte. Don’t break
battery to avoid electrolyte leakage.
e)
Do charge battery at well ventilated area.
f)
Don’t let the positive terminal port touch negative port while connect battery wiring.
Otherwise, the spark may ignite the flammable gas from battery to cause explosion.
g)
Don’t apply battery if the battery power is not sufficient, otherwise, the battery aging will
speed and accordingly battery service life will be shorten or battery may explode.
h)
The main switch should always be kept in the "ON" position during operation.
Ver. 3/Rev. 1; Data: 03.02.2022;
39
Summary of Contents for YDE6500E
