1. SL100_User’s Manual_2018
31
8. options
8.9 Skirting
• Unfold the skirt on the ground in front of the stage and align the middle of the skirt with the middle of the stage.
• Using the pockets sewed on the skirt, hang it on hooks located on the edge of the stage.
• Install the skirt starting from the middle toward the outside.
8.10 Adjustable Stairways
• Remove the lynch pin to unlock each stairway locking device.
• Pull the handle and disengage the locking device. Position the stairway.
• Insert the stairway in brackets along the floor sides. The first step should lay flat on the
stage floor.
• Move the locking device to the proper position and push the handle back to maintain position.
• Pin to secure selected position. Maximum allowable load is 600 lbs (272 kg).
8.11 cylinder locks
These cylinder locks must be installed when downstage corner posts are not used. They are not to be considered a complete substitute to
the corner posts. The rigging capacity of the downstage panel is notably reduced. Please refer to the Rigging Plan for more information.
• Raise the downstage roof panel completely.
• Slide the cylinder lock over the cylinder rod.
• Link the extremities of the safety cable under the cylinder lock using
the spring hook.
• Slightly lower the downstage roof panel to secure the cylinder lock.
8.12 Stage REVERSIBILITY
Reversibility implies that the passenger’s side of the stage normally used as the upstage can also be used as the downstage.
• If you have not purchased two (2) additional side overhang rigging beams, remove the downstage right overhang rigging beam
and install it in the upstage left position. Pin and secure.
• Remove the downstage left overhang rigging beam and install it in the upstage right position.
Pin and secure. Proceed with stage setup.
Cylinder
lock
