1. SL100_User’s Manual_2018
11
4. Trailer Setup
4. Trailer Setup
4.1 Lowering Roof Structure
• Unfasten all windwall bottom hooks, if applicable.
Beware of flying windwall hooks in windy conditions.
To protect and extend the life span of your windwall, pull it onto the stage floor as the roof is being lowered.
CAUTION
• Remove the locking pins from the corner posts.
• Start the engine, raise the upstage roof panel and attach both corner posts together with rubber bungee straps.
• Raise the downstage roof panel and attach both corner posts together with bungee straps.
• Raise the roof and remove the column pins from the bottom sections.
• With the engine running, lower the roof as evenly as possible.
A height difference of no more than 4’’ to 6’’ (10 to 15 cm) between the front and the rear of the trailer is acceptable.
• Resume lowering the roof.
• Insert the pins in the bottom sections of the front and rear telescopic columns.
• Slightly raise the roof structure in order to remove the weight on the pins from the upper sections of the front and rear
telescopic columns.
• Remove the pins from the top sections of the front and rear telescopic columns.
• Slide in the upstage and downstage corner posts.
• Raise the roof panels slightly to disengage the cylinder locks, if applicable. Lower the roof all the way down.
• Lower the roof panels to working height.
Untie the corner posts before they reach the stage floor. They will drag on the stage floor during closing of roof
structure. Make sure they do not get stuck or collide together. Severe damage to the corner posts and the
floor could occur.
CAUTION
• Remove the corner posts.
• Remove and fold the windwall in an area clear of any material.
• Remove the banner supports, all equipment rigged to the roof and skirting.
• Raise the roof panels back to the horizontal position.
• Remove the extension platforms.
4.2 Closing Floor and Roof Panels
• Remove the floor cross braces from each corner.
• Remove the cover plates from the floor hinges.
Remember to remove the floor cross braces otherwise damage will be caused to the trailer and the floor structures.
Remember to remove the cover plates otherwise damage will be caused to the deck and the floor structures.
CAUTION
• Load all equipment to be transported into the trailer unit. All cargo must be properly secured.
Refer to point 5.7.
