ST Micro Connect 2
Compliance statement
7912386 Rev 12
49/58
Appendix F
Compliance statement
The ST Micro Connect 2 equipment has been designed and tested to meet the
requirements of the 89/336/EEC EMC directive, and complies with ITE EN55022 Class B
standards for radiated and conducted emissions, and ITE EN55024 immunity standards,
when tested under the conditions and requirements detailed in
Section F.1
.
F.1 Conditions
and
requirements for CE compliance
This product respects the EMC requirements of the European guideline 89/336/ EEC under
the following conditions.
F.1.1 Anti-static
precautions
Observe the following precautions for handling Electrostatic Sensitive Devices. Failure to
observe these precautions may result in an interruption of operation, loss of data, or
damage to the product:
1.
Any tester, equipment, or tool used at any production step, or for any manipulation of
semiconductor devices, or any product containing semiconductor devices, must have
its shield connected to GROUND.
2.
The product should be placed on a work table covered by an antistatic surface (with
superficial resistivity equal to or higher than 0.5MOhm/cm
2
). The work table surface
should be properly earthed.
3.
The work table must be free of all non-antistatic objects.
4.
It is recommended that the operator wear an antistatic wrist strap, connected to the
grounded work table surface.
F.1.2
EMC radiated emissions test conditions
To fully comply with the 89/336/EEC EMC directive ITE EN55022 Class B standards for
radiated emissions, the following conditions of operation must be observed:
1.
The ST Micro Connect 2 must be powered using the supplied power supply with pre-
fitted EMC ferrite.
2.
Because of the highly configurable and flexible nature of the ST Micro Connect 2
product, any change in mode of operation outside of that provided as part of the
ST Micro Connect 2 product hardware and software support packages, may result in a
condition where the product fails to comply with ITE EN55022 Class B standards for
radiated emissions. Users of the ST Micro Connect 2 hardware who operate the
product in such a mode, should consider the product as part of their own system and
EMC test it as such.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
