ST Micro Connect 2
Configuration using the stmcconfig utility
7912386 Rev 12
21/58
5
Configuration using the stmcconfig utility
This chapter describes the host utility
stmcconfig
that provides a variety of options to
report, configure and maintain the ST Micro Connect 2 remotely. It also facilitates firmware
upgrades.
stmcconfig
’s command line options are listed in
Table 2
and detailed in the
following sections in alphabetical order.
Note:
Some of these commands require a good understanding of networking principles.
To pass commands to an ST Micro Connect 2,
stmcconfig
uses the ST Micro Connect 2’s
IP address as identification. For a variety of reasons this IP address may not be known.
Section 5.6
describes how to identify the IP assignment of a particular ST Micro Connect 2
and
Section 5.7
describes how to identify all the ST Micro Connect 2s on a network.
Table 2.
stmcconfig options
Option
Description
--dhcp enable | disable
(1)
1.
Options that reconfigure the ST Micro Connect 2, complete by performing a reboot.
Enable or disable automatic network configuration of
Ethernet interface.
--firmware-downgrade
(1)
Select alternate ST Micro Connect 2 firmware.
--firmware-upgrade
(1)
<
firmware dir
> Upgrade firmware in Flash.
--firmware-version
Report firmware version.
--gateway
Assign, remove or report the current gateway.
--help
Display the
stmcconfig
options.
--identify-all
Report network addresses of any ST Micro
Connect 2s connected to the network.
--identify <
MAC
>
Report network addresses of the ST Micro
Connect 2 with MAC address <
MAC
>.
--ifconfig-eth
(1)
[
Ethernet
arguments
]
Report or configure Ethernet network interface
settings.
--ifconfig-usb
(1)
[
USB arguments
]
Report or configure USB network interface settings.
--ip <
ip address
>
ST Micro Connect 2 network address. Used in
conjunction with many
stmcconfig
options, as
described in the following sections.
--lcd-message [
message
]
Display message on the ST Micro Connect 2 LCD.
Without a message parameter, the message display
is cleared.
--output <
file name
>
Redirect output to file.
--reset
(1)
Reset the ST Micro Connect 2.
--restore-network-config
(1)
Restore factory default network configuration.
--serial-relay [
arguments
]
Report or configure serial redirect.
--show-log [<
log name>
]
List available log files or display named log.
--status
Report on system status.
--version
Display the ST Micro Connection Package version.
--visual [<
n flashes>
]
Visually identify a ST Micro Connect 2 by flashing
LEDs.
n flashes
defaults to 10.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
