ST Micro Connect 2
LCD interface
7912386 Rev 12
13/58
2 LCD
interface
The ST Micro Connect 2 has a sixteen character by two line LCD that is used to display
status information and to configure the ST Micro Connect 2.
The LCD has two modes of display:
●
Status display
, see
Section 2.1
These pages display configuration and status information for the ST Micro Connect 2.
●
Configuration menu
, see
Section 2.2
This menu can be used to configure various aspects of the ST Micro Connect 2 such
as Ethernet IP address and Gateway IP address.
On boot-up, the LCD displays a ready message then the pages from the
Status display
are
displayed in turn. Press the
Select
button from the
Status display
to access the
Configuration menu
. The
Next
button can be used in both displays to navigate the various
pages.
Note:
The LCD can also be used to display messages using the host utility,
stmcconfig
(see
Section 5.10 on page 26
). Messages that are longer than 16 characters are scrolled.
2.1 Status
display
The
Status display
pages are organized in a circular list. If no buttons are pressed, each
page is displayed for 30 seconds after which the next page in the list is displayed.
The
Status display
pages are:
1.
Ethernet IP
2.
Ethernet Mask
3.
Default Gateway
4.
USB IP
5.
USB Mask
6.
Connect Status
7.
Version
(software and hardware version numbers)
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
