UM0935
Running the IBU UI tool
Doc ID 17398 Rev 3
31/53
Figure 22.
Transfer sequence of one byte of SPI
Therefore, this interface allows any SPI interface based slave device to be connected and
tested.
3.6
Using the UART1(SCI1) interface of the 30-pin header
To use the UART1 interface, it must be selected by sending the command from the DLL, as
mentioned in the DLL help file. After this, the board is ready to be used in UART1 mode. The
section below explains how the tool and its features behave once selection has been made
using the DLLs and it also explains how the hardware setup is to be done.
below
shows the interpretation of the 30-pin header when it is configured in UART1 mode.
Along with the UART1 (SCI1) communication interface, the 30-pin header in UART1 (SCI1)
interface mode also consists of 20 configurable GPIOs in various modes. Of these 20
GPIOs, 4 can additionally be configured as analog channels and another 4 GPIOs can be
configured as PWM channels.
Summary of Contents for STEVAL-PCC009V2
Page 4: ...Contents UM0935 4 53 Doc ID 17398 Rev 3 Appendix D Tables and figures 50 Revision history 52...
Page 42: ...UM0935 Schematics and BOM list Doc ID 17398 Rev 3 42 53 Figure 32 10 pin com interface V...
Page 43: ...Schematics and BOM list UM0935 43 53 Doc ID 17398 Rev 3 Figure 33 30 pin com interface V...
