Getting started
UM0935
12/53
Doc ID 17398 Rev 3
2.4.1 Power
supply
The board is directly powered by the USB mini B-type connector J4 (bus powered). There is
a power LED D2 available onboard, as soon as the board is powered, using the USB mini-B
cable, it lights up.
2.4.2 Jumper/header
settings
●
J1: J1 is the 10-pin header available on the IBU UI board. There are 8 GPIOs, GND,
and VDD (3.3 V) lines available, as shown in
below:
Figure 7.
Jumper J1
●
J2: J2 is the 30-pin header available on the IBU UI board. There are 24 GPIOs, GND,
and VDD lines available, as shown in
below:
Figure 8.
Jumper J2
●
J3: This is the standard 20-pin JTAG header available on the board. This can be used
by the user to run the board in debug mode using any JTAG based debugger for an
STM32 device.
●
SW1: this is the reset switch that can be used to reset the board at any point.
Summary of Contents for STEVAL-PCC009V2
Page 4: ...Contents UM0935 4 53 Doc ID 17398 Rev 3 Appendix D Tables and figures 50 Revision history 52...
Page 42: ...UM0935 Schematics and BOM list Doc ID 17398 Rev 3 42 53 Figure 32 10 pin com interface V...
Page 43: ...Schematics and BOM list UM0935 43 53 Doc ID 17398 Rev 3 Figure 33 30 pin com interface V...
