Element-MF Stove
41
Clinker/Ash Removal – Element-MF with the Multi-Fuel Pot
Once a clinker/ash has formed in the burn pot,
it must be removed
or the unit will go out.
The St. Croix Burn system is designed to remove the clinker/ash without loosing the fire
in the burn pot. It is a 3-step system.
1.
The Coal Rake. This is a “fork” shaped device that will allow the operator to
“shave” the burning coals off the top of the clinker, separating the 2 areas of the
burn pot. The burning fuel on top and the clinker on the bottom.
2.
The Slide-Out Bottom. This allows the bottom to be pulled out so the clinker can
drop out of the bottom of the burn pot.
3.
The program on the control board. To drop the clinker you set the board to the #1
setting for a couple of seconds and then return the setting to the desired level. This
starts a timed delay in the program allowing the clinker to be removed, the coals
to be dropped to the bottom of the pot, and the Burn to become balanced again
before the board resumes on the setting of your choice.
Figure 24
(Also see figure 2 on page 7)
Summary of Contents for Element-MF
