7
8.
Are there any adjustments that can be made, through the control board, to the amount of
fuel that is fed into the burnpot?
Answer: There are several ways to adjust the amount of fuel that is
fed into the burnpot. The feedrate can be fine-tuned while the
Stove is in operation by
pressing and holding
the “Auger Feed”
button down and then
either
pressing the “Heat Level High” button
to advance the feedrate higher,
or
pressing the “Heat Level Low”
button to decrease the feedrate.
There are 5 levels on the control board and they are indicated by a
single flash of the LED’s. The default setting is the center LED.
This gives 2 adjustments increasing the feedrate (LED’s 4 & 5)
and 2 adjustments decreasing the feedrate. (LED’s 1 & 2) The ON
time is
increased or decreased
.25 seconds with each adjustment.
9.
Are there any adjustments that can be made, through the control board, to the Combustion
Fan voltage to help adjust the draft?
Answer: The Draft can be adjusted in a similar fashion as mentioned in
the previous example.
The Fan voltages can be fine-tuned while the Stove is in operation
by
pressing and holding
the “Auger Feed” button down and then
either
pressing the “Trim High” button to advance the voltages
higher,
or
pressing the “Trim Low” button to decrease the fan
voltages.
There are 5 levels on the control board and they are indicated by single
flash of the LED’s. The default setting is the center LED. This gives 2
adjustments increasing the voltage (LED’s 4 & 5) and 2 adjustments
decreasing the voltage. (LED’s 1 & 2) The voltage is
increased or
decreased
2.5 volts with each adjustment.
