Ashby-P Insert
51
10.
Are there Cycle Time adjustments on the Control Board for different types of fuel?
Answer: There are 4 individual programs on the control board, each
with a different Cycle time. The Ashby-P only uses Programs 3 and 4
Your Ashby-P has been factory set to Program 3. When
reprogramming the control board, you will see LED light flash, as
shown in the figure to the right. The LED lights flash in the following
manner:
1 -
Program 1.
The Cycle Time is 11.5 seconds. THIS PROGRAM IS
ONLY TO BE USED WITH THE ASHBY-MF MODEL.
(DO
NOT USE THIS PROGRAM WITH THE ASHBY-P).
2 -
Program 2.
The Cycle Time is 13 seconds. THIS PROGRAM IS
ONLY TO BE USED WITH THE ASHBY-MF MODEL.
(DO
NOT USE THIS PROGRAM WITH THE ASHBY-P).
3 -
Program 3.
The Cycle Time is 11.5 seconds.
THIS IS THE
DEFAULT PROGRAM FOR USE WITH THE ASHBY-P.
This
program is for use with
Pellets, Cherry Pits and a 50/50 Percent
Mixture of Pellets and Corn
(See fig. 19 on page 34). (DO NOT
USE THIS PROGRAM WITH THE ASHBY-MF).
4 -
Program 4.
The Cycle Time is 10 seconds.
This Program offers
Self-Ignition and is only for units that have the Versa Grate
system & Igniter installed
. This program is for use with
Cherry
Pits only
(See fig. 19 on page 34). (DO NOT USE THIS
PROGRAM WITH THE ASHBY-MF).
11.
How do I change to a different Program on the control board?
First the Insert must be turned off and cooled down.
Step 1 - The Thermostat switch must be in the
Manual
position.
Step 2 – Press and hold the
Auger Feed
Button.
Step 3 – Press the
Trim High and Low
Buttons. Release all 3 buttons
at the same time.
Step 4 – Observe the LED light flashing according to the Program
chosen. Program 1 flashes once, Program 2 flashes twice, Program 3
flashes three times and Program 4 flashes 4 times.
Changing the Cycle Time will change the BTU Input of the Insert. The
longer the Cycle time the lower the BTU rating.
Figure 35
