SST SST-PFB-SLC, User Manual

Page: 70 / 117

SST-PFB-SLC User’s Guide
62
8.2 FDL Messages
To enable FDL messages, issue the EnaMsg command from the serial port
while in configuration mode and talking to the scanner. The state of FDL
messages (enabled/disabled) is stored in flash when you exit configuration
mode.
Setting up a Message
To set up a message block, select which message block (0-3) being used. This
determines which of the areas in the M0 and M1 files will be used.
Set the appropriate values in the FDL message control block for the message,
in the corresponding area of the M0 file.
The following table shows the offsets to the message control block elements
for each of the four message control blocks (0-3), and their locations in the
M0 file.
Offset Name 0 1 2 3
0 CntCfg 1122 1252 1382 1512
1 reserved 1123 1253 1383 1513
2 reserved 1124 1254 1384 1514
3 DstStn 1125 1255 1385 1515
4 DstSap 1126 1256 1386 1516
5 SrcSap 1127 1257 1387 1517
6 FrmCntrl 1128 1258 1388 1518
7 TxLen 1129 1259 1389 1519
8-129 TxData 1130-1251 1260-1381 1390-1511 1520-1641