SST SST-PFB-SLC, User Manual

Page: 42 / 117

SST-PFB-SLC User’s Guide
34
This procedure describes the steps to create a binary file to configure the
SST-PFB-SLC as a DP master. In this procedure, the network being
configured consists of only Profibus DP remote I/O devices. Refer to the
COM PROFIBUS software documentation for more detailed information.
each step.
1. Create a new file ( File/New).
2. Select the master station number. This sets the station number of the
scanner on the Profibus network.
3. For the master station type select SST-PFB-SLC Master. If the
update files for the SST-PFB-SLC have not been installed, set the
master station type to be IM 308-C and set the host type to S5-115U/
CPU 944A or S5-115U/CPU 944B.
4. Select Configure/Bus parameters...
• Set the baud rate for the network.
• If there is a repeater on the bus, check the Repeater on bus
checkbox.
• If there are FMS devices on the network, change the Bus
profile to DP/FMS.
• If the network has only Profibus DP devices, leave the bus
profile as PROFIBUS-DP. COM PROFIBUS takes care of
assigning appropriate default values for all the network
parameters.
5. Click OK.
6. Select Configure/slave parameters... to create and configure each
slave:
• select the slave station number
• select the slave device family
• select the slave station type
• select the slave module type